Internal Combustion Engine Modeling in CONVERGE
This two-day course offers an introduction to CONVERGE for internal combustion (IC) engine modeling. You will learn about the CONVERGE solver and modeling options while working through a typical IC engine case from start to finish. Because CONVERGE has a completely automated meshing process, you do not need to spend any time preparing the volume mesh, which simplifies the case setup process.
During this course, you will have plenty of time for hands-on practice in CONVERGE Studio. You will practice preparing the surface and setting up the case for several types of IC engines (including diesel, PFI spark-ignited and multi-fuel premixed).
Upon the completion of this course, you will know how to:
Set up solver parameters and data files
Set up appropriate boundary and initial conditions based on available data
Control grid settings throughout the computational domain
Set up fuel injection via spray modeling
Set up detailed chemical kinetics for accurate combustion and emissions modeling
Set up wall heat transfer modeling in CONVERGE and output heat transfer quantities for thermal analysis
Set up additional modeling options such as turbulence and sources
Run CONVERGE and monitor your simulation
Post-process results in CONVERGE Studio
Prerequisites
Surface Preparation with CONVERGE Studio for IC Engines
Who should attend this course
This course is intended for all new users interested in using CONVERGE for IC engine modeling. This course can also be used as a refresher for experienced or occasional users of previous versions of CONVERGE. This course will not cover surface preparation.
A deposit of $50.00 (USD) will be charged to your credit card upon completion of the registration process. This deposit will be refunded in full within seven business days after you attend the training. If you cannot attend the training, please cancel your registration through the registration system or send a cancellation request to [email protected]. Cancellations must be submitted at least three business days before the first day of the training course to receive a full refund. If you cancel your registration fewer than three business days before the first day of the training course or if you do not attend the training, you will forfeit your deposit.
